Radio Shack ET-927 owner manual 43-1097a.fm Page 21 Tuesday, August 31, 1999 1001 PM

Page 21

43-1097a.fm Page 21 Tuesday, August 31, 1999 10:01 PM

Problem

Solution

 

 

 

 

The phone does not work or works

Be sure the base’s phone line cord and

poorly.

AC adapter are correctly and securely

 

connected. If that does not help, unplug

 

the base’s AC adapter from the AC outlet

 

and disconnect the handset’s battery

 

pack. Wait 3 minutes, then reconnect the

 

battery pack and plug the AC adapter

 

back into the AC outlet.

 

 

The handset battery pack does not

Check the charging contacts on the

charge.

handset and base. If they are dirty, clean

 

them with a pencil eraser.

 

 

The handset does not ring or receive

Be sure the handset’s ringer is turned on.

a page.

 

Adjust the base’s antenna so it stands

 

 

straight up.

 

 

 

Move closer to the base.

 

 

 

Move the base away from noise sources.

 

 

 

The battery pack might be weak. Charge

 

the battery pack by placing the handset

 

on the base for 15–24 hours.

 

 

 

Return the handset to the base to reset

 

the security code.

 

 

The handset stops working or works

Move the handset closer to the base.

poorly during a call.

 

Adjust the base’s antenna so it stands

 

 

straight up.

 

 

 

Be sure the handset’s battery pack is

 

charged. (If the battery power is too low,

 

it does not have enough power to light

 

the BATT LOW indicator.)

 

 

If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your phone to your local RadioShack store for assistance.

21

Image 21
Contents ET-927 Features 43-1097a.fm Page 3 Tuesday, August 31, 1999 1001 PM FCC Statement Read this Before InstallationContents Installing HANDSET’S Antenna InstallationSelecting a Location Placing on a Desk TopMounting on a Wall Plate For the best re Ception, raise Mounting Directly on the Wall Plug the ET-927’s AC cord into a standard AC outlet Preparation Connecting and Charging the Battery PackSetting the Dialing Mode Setting the Ringer’s Volume Adjusting RingersChecking/Setting the Ringer Tone Turning On/Off the RingersUsing Redial Adjusting the VolumeOperation MAKING/ANSWERING CallsUsing Mute Using Tone Services on a Pulse LineUsing Flash Memory Dialing Special FeaturesStoring a Number Storing a PauseChain Dialing Service Numbers Using the IntercomTesting Stored Emergency Numbers Dialing a Stored Number Paging from the Handset to the Base Using AN Optional HeadsetMake or receive calls as you would normally Problem Solution Troubleshooting43-1097a.fm Page 21 Tuesday, August 31, 1999 1001 PM OUT-OF-RANGE Indications Care and Maintenance Replacing Battery Pack Lightning FCC Wants YOU to Know43-1097a.fm Page 26 Tuesday, August 31, 1999 1001 PM 43-1097a.fm Page 27 Tuesday, August 31, 1999 1001 PM RadioShack Division of Tandy Corporation Fort Worth, Texas