Radio Shack ET-926 owner manual Read this Before Installation, FCC Statement

Page 3

43-1096.fm Page 3 Tuesday, August 17, 1999 3:47 PM

Important Note: Cordless phones such as this one require AC power to operate. When the AC power is off, you cannot dial out or receive incoming calls using your ET-926. To be safe, you should also have a phone that does not need AC power to operate (not a cordless phone) so you can still make and receive calls if there is an AC power failure.

We recommend you record your phone’s serial number here. The num- ber is on the bottom of the base.

Serial Number __________________

Warning: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture.

 

CAUTION

!

 

 

 

RISK OF ELECTRIC SHOCK.

 

 

 

DO NOT OPEN.

 

 

 

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SERVICE- ABLE PARTS INSIDE. REFER SERVIC- ING TO QUALIFIED PERSONNEL.

This symbol is intended to alert you to the presence of uninsulated dan- gerous voltage within the product’s enclosure that might be of sufficient magnitude to constitute a risk of electric shock. Do not open the product’s case.

This symbol is intended to inform

!you that important operating and maintenance instructions are in-

cluded in the literature accompany- ing this product.

READ THIS BEFORE INSTALLATION

Each device that you connect to the phone line draws power from the phone line. We refer to this power draw as the device’s ringer equivalence number, or REN. The REN is on the bottom of the base.

If you are using more than one phone or other device on the line, add up all the RENs. If the total is more than five, your phones might not ring. In rural ar- eas, a total REN of three might impair ringer operation. If ringer operation is impaired, remove a device from the line.

FCC STATEMENT

This telephone complies with Part 68 of FCC Rules. You must, upon re- quest, provide the FCC Registration Number and the REN to your phone company. These numbers are on the bottom of the base.

Note: You must not connect your phone to any of the following:

coin-operated systems

party-line systems

most electronic key phone sys- tems

3

Image 3
Contents ET-926 Features FCC Statement Read this Before InstallationContents Installation Selecting a LocationPlacing the Base on a Desk Top Mounting the Base on a Wall Plate Fm Page 7 Tuesday, August 17, 1999 347 PM Mounting the Base Directly on the Wall Fm Page 9 Tuesday, August 17, 1999 347 PM Connecting and Charging the Battery Pack Setting the Dialing Mode Using the Belt Clip Setting the Ringer TONE/VOLUMEMaking Receiving Calls Setting the Handset VolumeUsing Redial OperationPaging Using FlashStoring a Number in Memory Memory DialingChain-Dialing Service Numbers Entering a PauseDialing a Memory Number Testing Stored Emergency Numbers Troubleshooting Fm Page 19 Tuesday, August 17, 1999 347 PM Care and Maintenance Replacing Battery Pack Lightning FCC Wants YOU to KnowFm Page 23 Tuesday, August 17, 1999 347 PM RadioShack