43-1086.fm Page 17 Tuesday, August 17, 1999 2:39 PM
Problem |
| Suggestion |
|
|
|
|
|
|
Handset does not ring or receive a | • | Return the handset to the cradle to |
page. |
| recharge the battery pack. |
| • | Lift the base’s antenna to a fully verti- |
|
| cal position. |
| • | Move the handset closer to the base. |
| • Move the base away from other elec- | |
|
| trical devices. |
|
|
|
The handset stops working or works | • | Move the handset closer to the base. |
poorly during a call. | • | Be sure the handset’s battery pack is |
| ||
|
| charged. (If the battery pack power is |
|
| too low, it does not have enough |
|
| power to light the TALK/BATT LOW |
|
| indicator.) |
| • | Lift the base’s antenna to a fully verti- |
|
| cal position. |
| • | Make sure the charging contacts on |
|
| the handset and base are clean. |
| • | If the base lost power while the hand- |
|
| set was off of it, the security access- |
|
| protection code might have changed. |
|
| Remove the handset from the base (if |
|
| it is on the base). Restore power to |
|
| the base, then place the handset back |
|
| on the base. The CHARGE indicator |
|
| lights, indicating that the code is set |
|
| again. |
|
|
|
If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your phone to your local RadioShack store for assistance.
17