Radio Shack ET-686 owner manual Setting the Dialing Mode

Page 11

43-686.fm Page 11 Friday, September 10, 1999 3:13 PM

Notes:

When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear an error tone when you press LINE 1 or LINE 2. If this happens, return the handset to the base for about five seconds. This resets the security access-protec- tion code.

If the battery pack gets weak during a call, the handset beeps every 3 seconds and the line indicators flash. When this happens, you can- not make another call on the phone until you recharge the battery pack.

Use a pencil eraser to clean the charging contacts on the handset and the base about once a month.

If the battery pack becomes com- pletely discharged or the base loses power while the handset is away from it, the security code might be lost. To reset the code, return the handset to the base. If it was the handset that lost power, leave the handset on the base to charge the battery pack.

About once a month, fully discharge the battery pack by keeping the handset off the base until the low battery indications (flashing line indi- cators and beeping) appear. Other- wise, the battery pack loses its ability to fully recharge.

The supplied battery pack should last for about a year. When the bat- tery pack loses its ability to fully recharge, order a replacement bat- tery pack at your local RadioShack store (see “Replacing the Battery Pack” on Page 25).

SETTING THE DIALING MODE

Set PULSE-TONEon the back of the base for the type of service you have. If you are not sure which type you have, do this test.

1.Be sure PULSE-TONEis set to

TONE.

PULSE-TONE

11

Image 11
Contents Line 900 MHz Cordless Speakerphone Features Fm Page 3 Friday, September 10, 1999 313 PM FCC Statement Read this Before InstallationContents On a Desk Top InstallationConnecting to the Phone Lines Mounting the PhoneOn a Wall or Wall Plate Fm Page 8 Friday, September 10, 1999 313 PM Plug the second cord into the sec- ond phone jack Connecting and Charging the Battery Pack Setting the Dialing Mode On the Base Adjusting the RingerOn the Handset Operation Using the HandsetAdjusting the Speakerphone Volume Using SpeakerphoneUsing Mute Using HoldSwitching Between the Handset and Speakerphone Way Conferencing Using Both Handset SpeakerphoneMaking a Conference Call Using the ET-686 with Extension Phones Using RedialUsing Tone Services on a Pulse Line Using FlashStoring a Number in Memory Memory DialingDialing a Memory Number Chain-Dialing Service NumbersTesting Stored Emergency Numbers Entering a PauseUsing a Headset Problem Suggestion TroubleshootingFm Page 23 Friday, September 10, 1999 313 PM Care and Maintenance Replacing Battery Pack Lightning FCC Wants YOU to KnowFm Page 27 Friday, September 10, 1999 313 PM RadioShack