Radio Shack ET-686 owner manual Fm Page 23 Friday, September 10, 1999 313 PM

Page 23

43-686.fm Page 23 Friday, September 10, 1999 3:13 PM

Problem

Suggestion

 

 

 

 

Handset does not ring or receive a

Lift the base’s antenna to a vertical position.

page.

 

Move the handset closer to the base.

 

 

 

 

Move the handset and base away from other electri-

 

cal devices.

 

 

 

Recharge the battery pack.

 

 

If the base loses power while the handset is off of it, the security access-protection code might change. Restore power to the base, then place the handset back on the base and leave it there for a few seconds.

If you still have problems, disconnect the phone. If other phones on the same line work properly, the fault is in this phone or its installation. If you cannot find the prob- lem, take your phone to your local RadioShack store for assistance.

23

Image 23
Contents Line 900 MHz Cordless Speakerphone Features Fm Page 3 Friday, September 10, 1999 313 PM FCC Statement Read this Before InstallationContents On a Desk Top InstallationConnecting to the Phone Lines Mounting the PhoneOn a Wall or Wall Plate Fm Page 8 Friday, September 10, 1999 313 PM Plug the second cord into the sec- ond phone jack Connecting and Charging the Battery Pack Setting the Dialing Mode On the Base Adjusting the RingerOn the Handset Operation Using the HandsetAdjusting the Speakerphone Volume Using SpeakerphoneUsing Mute Using HoldSwitching Between the Handset and Speakerphone Way Conferencing Using Both Handset SpeakerphoneMaking a Conference Call Using the ET-686 with Extension Phones Using RedialUsing Tone Services on a Pulse Line Using FlashStoring a Number in Memory Memory DialingDialing a Memory Number Chain-Dialing Service NumbersTesting Stored Emergency Numbers Entering a PauseUsing a Headset Problem Suggestion TroubleshootingFm Page 23 Friday, September 10, 1999 313 PM Care and Maintenance Replacing Battery Pack Lightning FCC Wants YOU to KnowFm Page 27 Friday, September 10, 1999 313 PM RadioShack