2.Press LINE 1 on the base. The LINE 1 SPEAKER indicator lights. Then listen for the dial tone.
LINE 1 | LINE 2 |
3.Press any number other than 0 on the base keypad.
Note: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code either.
If the dial tone stops, that line has tone service.
If the dial tone continues, that line has pulse service.
4.Press LINE 2, listen for the dial tone, and repeat Step 3.
If you have tone service on both lines, leave
TONE.
If you have pulse service on either line, set
ADJUSTING THE RINGER
The
12
can choose from a high or low ringer setting for the base and the handset.
On the Handset
At any time except during a call, press VOLUME to set the handset’s ringer vol- ume. The phone rings at the selected volume.
VOLUME
On the Base
Set RING VOL for each line (L1 or L2) on the back of the base to HI, LO, or OFF. With RING VOL set to OFF, the base’s ringer does not sound when a call is re- ceived, but the handset still rings when it is off the base (as does any other phone connected to the same line). The hand- set does not ring when it is on the base.
RING VOL