What to do If Something Goes Wrong
86
3
If You Cannot Make Copies as You Want

Adjust Image

Problem Cause Action
Copies are not sta-
pled. There are jammed staples in
the stapler. Remove jammed staples. See
⇒ P.109 “e Removing Jammed
Staples”.
Note
❒After removing jammed
staples or adding staples,
staples might not be eject-
ed the first few times you
try to use the stapler.
The number of copies exceeds
the capacity of the stapler. Check the stapler capacity.
See ⇒ P.38 “Staple”.
The stapler has run out of sta-
ple. Add staples. See ⇒ P.107 “d
Adding Staples”.
Staples are wrongly
positioned. Originals are not set correctly. Set originals correctly. See ⇒
P.38 “Staple”.
Misfeeds occur fre-
quently. Copy paper size setting is not
correct. Set the proper paper size. See
⇒ P.103 “Changing the Paper
Size”.
You cannot combine
several functions. Selected functions cannot be
used together. Refer to the combination
chart. See ⇒ P.80 “Combina-
tion Chart”.
Problem Cause Action
In Center/Border
mode, parts of the
original image are not
copied.
The margin is too wide. Set a narrower margin with
the user tools. See “01. Border
Erase Width” in ⇒ P.121 “2.
Adjust Image 1/3”. See “02.
Center Erase Width” in ⇒
P.121 “2. Adjust Image 1/3”.
Your original has narrow
margins on four sides.
In Image Repeat
mode, the original im-
age is not copied re-
peatedly.
You selected the same size
copy paper as originals, and
did not select the proper re-
production ratio.
Select copy paper larger than
the originals. See ⇒ P.72 “Re-
peat Image—Repeating an Image
over the Entire Copy”.
Select the proper reproduc-
tion ratio. See ⇒ P.72 “Repeat
Image—Repeating an Image over
the Entire Copy”.