28Using the projector
| Examine the projected image for |
rendition | Use the TINT option to make the adjustments: |
1 | From the projector control panel or remote control, press |
| the IMAGE menu key. |
2 | Using the cursor pad, scroll through the menu selections |
| and highlight TINT on the |
3 | Use the left (<) and right (>) arrow keys on the cursor pad to |
| adjust the color balance of the projected image. |
Restoring factory | If desired, you can restore the original factory settings by |
settings | selecting the SETUP menu key, using cursor pad to select |
| the RESET option, and depressing the right arrow key. Any |
| changes from the default setting are stored in memory for |
| that source. |
| Note: If for any reason the projector should not respond to |
| the control panel or remote control commands, you can |
| reset it by performing the following steps: |
1 | Turn off the unit and allow it to cool for at least 3 minutes. |
2 | Press the SET UP key on the projector control panel and |
| turn on the projector as you continue pressing the SET UP |
| key. Continue to press the SET UP key until the LEDs of the |
| SOURCE |
| green. |
3 | Release the SET UP key. |
4 | Reconfigure the projection settings for rear projectors, ceil- |
| ing mount, as required. |