Troubleshooting guide | Polaroid Polaview 220 manual

5 Troubleshooting

Troubleshooting guide

Symptom	Cause	Solution

Projector does not	Lamp-assembly door	Refer to lamp assembly
turn on;	not closed correctly	replacement procedure
no lights or fan		and verify proper installation
	No power to unit	Try another electrical outlet
	Blown input power fuse(s)	Call Polaroid Technical Support

Vertical bars appear	Nonstandard computer	Press the IMAGE key and
across the image	clock rate	scroll to PHASE;
		press < > cursor keys
		to remove the bars

Image is upside down	Incorrect projection	Press the SETUP key
	mode selected	and scroll to LOCATION;
		select DESKTOP or
		CEILING, as applicable

Image rolls vertically	Improper cables/	Check for correct cables
	loose cables	and snug connection
	Incorrect computer setup	Check computer video mode
		of operation (see Appendix B:
		Standards)

Image 35

Polaroid Polaview 220 manual Troubleshooting guide, Symptom Cause Solution

Contents

Polaview Specifications are subject to change without notice Radiate radio frequency energy and, if not installedProtection against such interference when operated in a Regarding safety, public health, environment Table of contents Appendix a Parts Appendix B Standards Storage, cleaning and care Replacing the lamp Introduction Items included with the projector What’s in the box? Computer/video compatibility Quick start Connector panel Introduction Introduction Your Polaview Model 220 Projector Detailed setupPolaroid Polaview Model 220 Projector and remote control Polaroid Polaview Model 220 Projector rear view Getting started Computer Inputs Outputs Stereo L R Redrive RS Connector panel Computer and VCR connections Labeled To VGA into the projector MAC/PC port see To Mac into the computer monitor port. Plug the end Panel see the illustration below Input composite jacks yellow on the projector connectorConnect one of the yellow RCA composite video cable Video source. Connect the yellow plug at the other end Use Sources 1 and 2 to connect Power receptacle and AC power switch Supplying power to the projector Turning on the projector Using the projector Focus the projected image with the Focus control either On the control panel or remote control. Adjust the imageSize by using the Zoom control on the control panel or Want to adjust the rear feet of the projector to position Control-panel keys Adjusts the brightness and contrast Image, when used with the cursorDecreases or increases the volume Adjusts the focus of the image Using the remote control Bass of the source connected to Controls the volume, balance, trebleBrightness, contrast, tint, phase Laser pointer Serves as a pointing device Zoom + Zooms in and out. Press + to make Focus + Adjusts the focus of the image Menu selections Resets all adjustments to Select the Setup menu to make adjustments toFollowing settings Or rear projection mode Image optimization Examine the projected image for horizontal noise bars or From the projector control panel or remote control, pressUsing the cursor pad, scroll through the menu selections Adjust brightness and contrast. The correct combination Control panel or remote control commands, you can Use the Tint option to make the adjustmentsAdjust the color balance of the projected image Changes from the default setting are stored in memory for Storage, cleaning and care Maintenance Replacing the lamp assembly Align the lamp-assembly slide rails with the slide-rail Unlock the lamp assembly by rotating the locking key onHalf revolution. Grasp the wire handle and gently pull Lamp assembly straight out of the unit Symptom Cause Solution TroubleshootingTroubleshooting guide If at any time you need help Where to get helpYour computer dealer Brasil Polaroid Offices and Service Centers New Zealand One Year Warranty Maintenance OG45 Replacement productOptional accessory Appendix a Parts Appendix a Appendix B Standards