4Introduction
Quick start
The following steps outline the basic setup procedure for connecting the projector to your computer. Detailed infor- mation about connections for various computer sources is described in Chapter 3, Detailed setup.
1Aiming the projector lens at the projection screen, place the projector on a solid, flat surface, at a right angle (perpendic- ular) to the projection screen and parallel to the floor. Place the projector the proper distance from your viewing screen.
2Connect your computer or video source to the projector (refer to the appropriate section for your computer, in Chap- ter 3, Detailed setup, for detailed instructions).
Connector panel
SOURCE 1 | SOURCE 2 | SOURCE 3 | SOURCE 4 | ||
L | R | L | R | STEREO | STEREO |
|
|
|
| MAC / PC | PC / MAC |
| VIDEO INPUTS |
| COMPUTER INPUTS | ||
Input: 120/230V~ 60/50Hz,5.0/2.5A
CAUTION !
For continued protection against the risk of fire, replace only with the same type and rating of fuse.
Double pole / Neutral fusing
Type and Rating: T
OUTPUTS
STEREO L R
REDRIVE RS 232
3You can simultaneously view your desktop computer moni- tor and project computer images with the projector by con- necting your monitor to the REDRIVE port on the rear panel OUTPUTS section. (Refer to the applicable setup procedure in Chapter 3, Detailed setup to connect your monitor.)
