Supplying power to the projector | Polaroid Polaview 220 guide

Detailed setup 15

Supplying power to the projector

After you connect the projector to your computer or video source, connect the power cord to the projector. The power- cord receptacle and AC power switch are located below the connector panel on the rear side of the projector.

Power receptacle and AC power switch

VIDEO INPUTS

Input: 120/230V~ 60/50Hz,5.0/2.5A

a

CAUTION !

For continued protection replace only with the sam

Double pole / Neutral fusi

Type and Rating: T Slow-

b

aPower receptacle

bAC power switch

To supply power to the projector:

1Plug the appropriate power cord into the power receptacle on the rear panel of the projector.

2Connect the power cord to a properly-grounded wall outlet.

Image 19

Polaroid Polaview 220 manual Supplying power to the projector, Power receptacle and AC power switch

Contents

Polaview Specifications are subject to change without notice Radiate radio frequency energy and, if not installedProtection against such interference when operated in a Regarding safety, public health, environment Table of contents Appendix a Parts Appendix B Standards Storage, cleaning and care Replacing the lamp Introduction Items included with the projector What’s in the box? Computer/video compatibility Quick start Connector panel Introduction Introduction Polaroid Polaview Model 220 Projector and remote control Detailed setupYour Polaview Model 220 Projector Polaroid Polaview Model 220 Projector rear view Getting started Computer Inputs Outputs Stereo L R Redrive RS Connector panel Computer and VCR connections Labeled To VGA into the projector MAC/PC port see To Mac into the computer monitor port. Plug the end Panel see the illustration below Input composite jacks yellow on the projector connectorConnect one of the yellow RCA composite video cable Video source. Connect the yellow plug at the other end Use Sources 1 and 2 to connect Power receptacle and AC power switch Supplying power to the projector Turning on the projector Using the projector Focus the projected image with the Focus control either On the control panel or remote control. Adjust the imageSize by using the Zoom control on the control panel or Want to adjust the rear feet of the projector to position Control-panel keys Adjusts the brightness and contrast Image, when used with the cursorDecreases or increases the volume Adjusts the focus of the image Using the remote control Bass of the source connected to Controls the volume, balance, trebleBrightness, contrast, tint, phase Laser pointer Serves as a pointing device Zoom + Zooms in and out. Press + to make Focus + Adjusts the focus of the image Menu selections Resets all adjustments to Select the Setup menu to make adjustments toFollowing settings Or rear projection mode Image optimization Examine the projected image for horizontal noise bars or From the projector control panel or remote control, pressUsing the cursor pad, scroll through the menu selections Adjust brightness and contrast. The correct combination Control panel or remote control commands, you can Use the Tint option to make the adjustmentsAdjust the color balance of the projected image Changes from the default setting are stored in memory for Storage, cleaning and care Maintenance Replacing the lamp assembly Align the lamp-assembly slide rails with the slide-rail Unlock the lamp assembly by rotating the locking key onHalf revolution. Grasp the wire handle and gently pull Lamp assembly straight out of the unit Troubleshooting guide TroubleshootingSymptom Cause Solution Your computer dealer Where to get helpIf at any time you need help Brasil Polaroid Offices and Service Centers New Zealand One Year Warranty Maintenance OG45 Replacement productOptional accessory Appendix a Parts Appendix a Appendix B Standards