Polaroid Polaview 220 manual Introduction

6Introduction

Note: Whenever you connect the projector to a computer or video source for the first time, the projector defaults to the factory settings. Due to operational differences between computers and video sources, it may be necessary to make minor adjustments to the settings. See Image optimization in Chapter 4, Using the projector for more information. The projector stores any modified settings, even when the power is turned off.

Note: Audio and video sources must be connected to the same computer or video source to be selected simultane- ously.

7To activate audio, connect the audio cables (from your com- puter, compact disc player, stereo, etc.) to the STEREO port that corresponds to the source connected in step 2. The audio source plays through speakers built into the projector. You may also connect amplified speakers or headphones to the OUTPUT connector labeled STEREO or L and R. This automatically deactivates the projector speakers.

Note: If you connect a mono or single-jack stereo source to the left (L) audio port (with nothing plugged into the right

(R) audio port), the sound emanates from both speakers.

8Begin your presentation.

Note: For setup procedures for the Computer IR (infrared) Receiver, refer to the separate instruction manual included in your Computer IR Receiver Kit.