Maintenance 31
Remove the | Unlock the lamp assembly by rotating the locking key on |
lamp assembly | the right side of the lamp assembly |
| half revolution. Grasp the wire handle and gently pull the |
| lamp assembly straight out of the unit. |
Replace the | Align the |
lamp assembly | channels inside the projector and gently slide the lamp |
| assembly into the projector. When the lamp assembly is |
| properly in seated in the projector, rotate the locking key |
| clockwise |
| Note: Take care not to touch the lamp in the new assembly. |
| The smallest oil deposit from your finger can significantly |
| shorten the life of the lamp. |
Replace the | Align the tabs on the bottom of the door with the slots |
in the door opening. Gently push the top of the door into | |
| place until the latch snaps into position. Turn the projector |
| on to verify that the lamp functions properly. |
| Note: The removal of the |
| safety switch that disconnects electrical power from the |
| lamp assembly. Improper installation of the lamp assembly |
| can prevent the safety switch from being reactivated. |
| Warning: When you replace the lamp assembly, always |
| disconnect the projector from its power source. Do not rely |
| solely on the safety switch to disconnect power from the |
| assembly. |
| Warning: The lamp assembly reaches extremely high tem- |
| peratures during normal operation. If you need to replace |
| the lamp assembly after operating the projector, let the unit |
| cool in Standby mode for at least 30 minutes before |
| attempting to remove the lamp assembly. When you use |
| the Standby mode, power is still being fed to the projector. |
| Do not try to replace the lamp assembly or any electronic |
| components unless you unplug the unit from the power |
| source. |
