Installation
±"016'"±"
The phone exits the setting mode if you:
•wait more than 2 seconds between key presses
•receive an incoming call
•press PLAY/STOP
•press TALK/FLASH on the handset
Start again at Step 1.
If the battery power is too low, the dial mode might reset to tone. If you are on a pulse line and cannot make a call, try
5'66+0)"6*'"*#0&5'6N5"4+0)'4" 610'181.7/'
You can select one of the handsets’ four different ringer tone/volume settings or turn the ringers off. You can also select a different tone/volume for each handset.
At any time, except during a call, repeatedly press
8or 9 to select the desired ringer setting. Each
time you press a button, the phone rings at the selected setting and H_d]ýJof[ý7 >_]^, H_d]ýJof[ý7ý Bem, H_d]ýJof[ý8ý>_]^, H_d]ýJof[ý8ýBem,ýor H_d][hýE\\ý
appears.
6740+0)"6*'"$#5'N5"4+0)'4" 1011(("
You can set the base’s ringer to high or low, or turn it off.
1.Press SET/RING. The phone’s currently set ring
sounds, and the current setting appears. When
the ringer is set to E<, the phone announces “Off.” ±
2.Repeatedly press SET/RING to change the
current setting. The system rings at each setting change and >_, Be, or E\ appears.
3.Press PLAY/STOP to store and exit the setting mode.
Even when you turn off the base’s ringer, you can still make or receive calls using this phone. Telephones on the same line and the handset (if its ringer is not turned off) still ring when there is an incoming call.
12