Memory Dialing, Using Mute, Using Flash

•The redial memory can also store tone entries and pause entries.

Using Mute

Press MUTE to talk to someone else in the room without the person on the other end of the phone line hearing your conversation. You can still hear the person on the other end of the phone line. Press MUTE to resume your phone conversation.

Using Flash

Flash provides the electronic equivalent of a switchhook signal for special phone services such as Call Waiting.

For example, if you have Call Waiting, you can put your current call on hold and answer a second call by pressing FLASH. Press FLASH again to alternate between the two calls.

Note: If you do not have any special phone services, pressing FLASH might disconnect your current call.

Using Tone Services on a Pulse Line

Some special services, such as bank- by-phone, require tone signals. If you have pulse service, you can still use these tone services by following these steps:

Dial the service’s main number.

When the service answers, press TONE/*. Any additional numbers you dial are sent as tone signals.

After you complete the call, press TALK/HANG UP or return the remote keypad to the base. The phone automatically resets to pulse dialing.

MEMORY DIALING

You can store up to 10 numbers, each with up to 16 digits.

Notes:

•To keep your accounts secure, we recommend you do not store your personal access code for services such as bank-by-phone in a memory location.

•When storing numbers for special services (such as alternate long distance or bank-by-phone), store the service’s main phone number in one memory location and numbers for additional information in other locations.

Storing a Number in Memory

1.Press and release MEM. The TALK/LOW BATT indicator flashes.

Note: If you do not press any button on the remote keypad within about 10 seconds, a buzz sounds and the phone exits the number storing process. Start again from Step 1.