2.Dial the desired number (up to 16 digits).
3.Press and release MEM again.
4.Press and release the memory location number
Use the memory index card at the bottom of the base to write the name in the respective memory location number on the memory index card.
Notes:
•If you receive a call while you are storing a number in memory, press TALK/HANG UP to answer the call. After the call, begin again at Step 1.
•To change a number stored in memory, simply store a new number in that memory location.
•To clear a memory location so no number is stored there, press MEM twice, then press the memory location number. Two long beeps sound, and the number is cleared from memory. If a buzz sounds, you did not successfully clear the memory location. Repeat the process.
Entering a Pause in a
Memory Number
In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. However, if you do, you should also store a pause after the access code to allow the outside line time to connect. After entering the access code, press REDIAL/PAUSE to enter a pause. To enter another pause, press REDIAL/PAUSE again.
Dialing a Stored Number
Lift the remote keypad, press TALK/ HANG UP, and when you hear a dial tone, press MEM then the memory location number. The phone dials the stored number.
Chain Dialing Service
Numbers
To quickly recall special services numbers (such as alternate long distance or bank by phone), store each group of numbers in its own memory location. When calling special services, dial the service’s main number first. Then, at the appropriate place in the call, press MEM, then the number for the location where the additional numbers are stored.
Note: If you use pulse dialing, be sure you have stored a tone entry in another memory location (see “Using
10