Radio Shack 43-3522 manual Attaching the Headset Holder

Page 7

leave it on the base to charge the battery pack.

If you will not use your phone for a long time, disconnect its battery pack. This helps increase the battery pack’s life.

The supplied battery pack should last about a year. If the battery pack does not hold a charge for more than 2 hours after an overnight charge, replace it with a new 3.6V, 600mAh Ni- Cd rechargeable battery pack with a connector that fits the socket in the battery compartment. You can order a replacement battery pack through your local RadioShack store. Install the new battery pack, place the remote keypad on the base, and charge the battery for 15 hours before using it.

Note: To avoid losing numbers stored in memory, you must install and begin charging the new battery pack within 2 minutes of removing the old one.

Warning: Dispose of the old battery pack promptly and properly. Do not burn or bury them.

Cautions:

You must use a replacement battery pack of the same size and type.

Do not dispose of the battery pack in fire because it might explode.

Do not open or mutilate the battery pack.

Be careful not to short the battery pack by touching the conducting materials, such as rings, bracelets, and keys. The battery pack or conductor might overheat and burn.

Important: The EPA certified RBRC® Battery Recycling Seal on the nickel-cadmium(Ni-Cd) battery indicates

RadioShack is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-THE-SHACK (1-800-843-7422) for information on Ni-Cd battery recycling and disposal bans/ restrictions in your area. RadioShack’s involvement in this program is part of the company’s commitment to preserving our environment and conserving our natural resources.

Attaching the Headset Holder

Put the headset holder into the slot on the back of the base and slide it into place.

6

Image 7
Contents Troubleshooting MHz Headset Phone FCC Statement Lightning symbol is Intended to alert you toLightning Selecting a Location InstallationUsing AC Power Connecting the PhoneConnecting, Charging, And Replacing The Battery Pack Attaching the Headset Holder Using the Belt Clip Connecting and Adjusting the HeadsetSetting the Ringer Setting the Dialing ModeOperation Memory Dialing Using MuteUsing Flash Using Tone Services on a Pulse LineEntering a Pause in a Memory Number Chain Dialing Service NumbersDialing a Stored Number Testing Stored Emergency Numbers TroubleshootingCare Limited One-Year Warranty