Setting the Dialing Mode

3.Insert the supplied AC adapter’s barrel plug into the AC 9V jack on the back of the base.

AC 9V Jack

4.To mount the phone on a wall plate, plug the other end of the modular cord into the wall plate jack. Then, with the power cord hanging over the bracket, align the TAD’s keyhole slots with the wall plate studs and slide the TAD downward to secure it.

To mount the phone directly on a wall, with the power cord and the modular cord hanging over the bracket, align the TAD’s keyhole slots with the screws and slide the TAD downward to secure it.

5.Slide the handset clip out of its retaining slot, rotate it 180° , then slide it back into its slot.

6.Plug one end of the supplied coiled handset cord into the jack at the left side of the base. Plug the other end into the handset’s jack.

7.Place the handset on the base.

8.Plug the adapter into a standard AC outlet.

When you first connect power, _ _ flashes on the message counter as the TAD runs a self-test. The TAD beeps and 00 appears when the test is complete.

Set PULSE/TONE for the type of service you have. If you are not sure which type you have, follow these steps.