If the incoming message tape is full, the TAD-716 an- swers a call after 10 rings, plays back the outgoing mes- sage, then waits 7 seconds for you to enter the remote operation security code. If you do not enter the correct code, the TAD-716 beeps and hangs up.
Rotate VOLUME counterclockwise to increase the vol- ume, or clockwise to decrease it.
To have the TAD-716 not answer calls, turn it off by rotat- ing VOLUME clockwise until it clicks. The message indica- tor turns off.
SCREENING CALLS
To screen calls, let the TAD-716 answer them. Listen to the caller's message through the TAD-716's speaker. If you decide to answer the call, pick up any phone on the same phone line as the TAD-716. The TAD-716 stops re- cording and resets to answer the next call.
Note: If you pick up the phone just as the TAD-716 an- swers, the TAD-716 might not stop recording the mes- sage. If this happens, press the telephone’s switchhook for about one second. The TAD-716 stops and resets to answer the next call.
13
