LCD DISPLAY
FIGURE 2 MAX IP LCD display
USING THE MAX IP PHONE
The following paragraphs describe how to use your MAX IP phone.
TO MAKE A CALL
1.Press the ON/OFF key to activate the phone. You hear a dial tone. (The phone icon and line states appear when the phone is active (see figure 3).) The line states are displayed at the far right of the display as “1” for line 1 and “2” for line 2, with the current line state being represented by the letter “c” for “connected,” “i” for “incoming,” “h” for “hold,” or “r” for “remote hold” (the line is on hold at the far end).
FIGURE 3 MAX IP phone icon
2.Dial the number as you would on a standard phone. The number appears on the LCD screen.
>Note: You can also predial the number while in Standby mode and press the ON/OFF key to connect the call.
To add a pause to the number you are predialing, press and hold the pound (#) key.
TO ANSWER A CALL
1.Press any key (except “*” key, MUTE, VOLUME UP or VOLUME DOWN).
When there is an incoming call, the phone rings (unless the ringer is turned off) and the phone LEDs and phone icon on the LCD screen flash.
TO END A CALL
1. Press the ON/OFF key.
TO TURN THE RINGER ON/OFF (IN STANDBY)
1. Press and hold the star key (*).
FIGURE 4 MAX IP ringer off icon
2Technical Services: 800.283.5936