4.Route the adapter cord through the narrow groove on the bracket.
Narrow
Groove
5.Plug the modular cord’s other end into the wall plate jack, then align the bracket’s keyhole slots with the wall plate studs and slide the base downward to secure it.
6.Plug the adapter into a standard AC outlet.
10
7.Press and lift out the handset hold- er, flip it over as shown, then snap it back into place so it holds the hand- set.
8.Lift the base’s antenna to a vertical position.
Directly on the Wall
For this mounting method, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base.
15 |
|
|
|
| 5/16" | ||
1. Drill two holes 3 /16 |
|
|
|
|
|
|
|
inches (100 mm) |
|
|
|
|
|
|
|
apart. Then thread a |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
screw into each hole, | 3 | 15/16" |
|
|
|
| |
letting the heads ex- |
|
|
|
|
|
|
|
tend about 5/16 inch (8 |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
mm) from the wall. |
|
|
|
|
|
|
|
2.Insert the bracket’s tabs into the base’s lower tab slots as shown, then press down on the bracket’s clips and insert them into the lower clip slots.
Lower
Tab Slots
Tabs
Lower Clip Slots