Cooper Lighting MD6CPxT4, MD6xT4, MD6xT6, MD6CPxT6 Distribution Selection & Trim Installation

Portfolio®

Distribution Selection & Trim Installation

Step 1. Install the proper lamp type and wattage into the socket. Make sure the new lamp does not have any fingerprints, dust, lint, etc.

NOTE: The lamp-socket assembly is installed onto the trim in one of three possible positions. These are labeled Narrow, Medium and Wide. The selected position determines the light distribution from the fixture.

Step 2. As shown in figure at right, the trim assembly includes six plastic lockout inserts. Remove and discard the two lockouts from the desired distribution positions. For example, if a Medium distribution is desired, remove the two lockouts closest to the “Medium” labels.

NOTE: It is intended that the remaining plastic lockouts remain

in place. This will help avoid any inadvertent distribution changes during re-lamping in the future.

Step 3. Secure the lamp-socket assembly in the desired distribution position with the two thumbscrews.

Step 4. Install the trim into the housing. The trim’s torsion springs pass through slots in torsion spring receivers inside the housing.

704530 Rev. A - 3 - Customer First Center · 1121 Highway 74 South · Peachtree City, GA 30269