Charge Your Headset
Charge your headset before using. Plug in your headset and place on a flat
NOTE Always charge at near room temperatures; never charge battery at temperatures below 0ºC (32ºF) or above 40ºC (104ºF).
charging time
30 min ...........................
Minimum charge before first use
1.5 hours ..........................
Full charge
Check Battery Level and Smart Sensor
To check the battery status, the headset must be powered on. While wearing the headset short press power button and a voice alert will advise you of the talk time you have remaining on your current charge. If you hear a beep after the remaining talk time your Smart Sensors are not calibrated properly. Remove headset from your ear and place headset flat on a
Charge Indicator Lights
Red Flashes | Battery Level |
S | More than 2/3 full |
S S | 1/3 to 2/3 full |
S S S | Less than 1/3 full |
USB Cable
A USB cable is supplied to allow you to charge the headset from a PC’s USB port. The PC must be powered on to charge via USB 2.0 or higher.
When the battery charge is very low, a tone and voice prompt will automatically occur.
Low Battery Warnings
Battery Level
30 minutes of talk time remaining (this alert only occurs during an active call)
Tone | Voice Prompt |
|
|
Double high tone every 15 | “Battery Low” repeats every |
minutes | 30 minutes |
10 minutes of talk time remaining
Triple high tone every 30 | “Recharge Battery” repeats every |
seconds | 3 minutes |
7