Cisco Systems 4100 manual Installing the Chassis

Page 7

Installation and Configuration

Installing the Chassis

Installing the Chassis

This section describes how to install the controller chassis.

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030

Waarschuwing Deze apparatuur mag alleen worden geïnstalleerd, vervangen of hersteld door bevoegd geschoold personeel.

Varoitus Tämän laitteen saa asentaa, vaihtaa tai huoltaa ainoastaan koulutettu ja laitteen tunteva henkilökunta.

Attention Il est vivement recommandé de confier l'installation, le remplacement et la maintenance de ces équipements à des personnels qualifiés et expérimentés.

Warnung Das Installieren, Ersetzen oder Bedienen dieser Ausrüstung sollte nur geschultem, qualifiziertem Personal gestattet werden.

Avvertenza Questo apparato può essere installato, sostituito o mantenuto unicamente da un personale competente.

Advarsel Bare opplært og kvalifisert personell skal foreta installasjoner, utskiftninger eller service på dette utstyret.

Aviso Apenas pessoal treinado e qualificado deve ser autorizado a instalar, substituir ou fazer a revisão deste equipamento.

¡Advertencia! Solamente el personal calificado debe instalar, reemplazar o utilizar este equipo.

Varning! Endast utbildad och kvalificerad personal bör få tillåtelse att installera, byta ut eller reparera denna utrustning.

Cisco 4100 Series Wireless LAN Controllers - Installation and Configuration Guide

 

78-17155-01

7

 

 

 

Image 7
Contents Installation and Configuration CLI Collecting Required Tools and Information Cisco 4100 Series Wireless LAN Controller HardwareInitial System Configuration Information Determining a Physical Location Page Installing the Chassis Installation and Configuration Installing the Chassis Performing Power On Self Test Connecting and Using the CLI ConsoleInstallation and Configuration Performing Power On Self Test Installation and Configuration Using the Startup Wizard Using the Startup WizardLogging Connecting the Network Distribution SystemExternal Equipment Connections to the Controller Connecting the Service Port InterfacesOptional management Network Where to Go from Here Connecting Access Points