Cisco Systems 4100 manual Installation and Configuration Installing the Chassis

Page 8

Installation and Configuration

Installing the Chassis

Aviso Somente uma equipe treinada e qualificada tem permissão para instalar, substituir ou dar manutenção a este equipamento.

Advarsel Kun uddannede personer må installere, udskifte komponenter i eller servicere dette udstyr.

The controller is shipped with rack-mounting ears attached, and rubber feet to mount in a separate bag. Install the controller as follows:

•When you are mounting the controller on a desktop or shelf, adhere the rubber feet to the bottom of the chassis, and place the chassis on any secure horizontal surface.

Note You can remove the rack mounting ears from the controller, if desired.

•When you are mounting the controller in an EIA-standard rack, attach the ears to the equipment rack using the factory-supplied screws.

Note You can remove the rubber feet from the bottom of the controller, if desired.

You have installed the controller chassis.

Cisco 4100 Series Wireless LAN Controllers - Installation and Configuration Guide

8

78-17155-01

 

 

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Installation and Configuration CLI Cisco 4100 Series Wireless LAN Controller Hardware Collecting Required Tools and InformationInitial System Configuration Information Determining a Physical Location Page Installing the Chassis Installation and Configuration Installing the Chassis Connecting and Using the CLI Console Performing Power On Self TestInstallation and Configuration Performing Power On Self Test Using the Startup Wizard Installation and Configuration Using the Startup WizardConnecting the Network Distribution System LoggingConnecting the Service Port Interfaces External Equipment Connections to the ControllerOptional management Network Connecting Access Points Where to Go from Here
Top Page Image Contents