Siemens 200 manual Settings of the base unit, Signaling method, Flash times „R key, Prerequisite

Page 18

Gigaset 200, GBR, A31008-G200-B101-1-7619

BASISST.FM

28.09.01

Settings of the base unit

Normally, no changes are necessary to settings in the base unit.

Settings in the base unit can be easily changed by using the mobile part if necessary.

Prerequisite:

The handset must be registered with the base unit.

Signaling method

You use this function to change to the pulse signaling method.

Factory default: Multifrequency signaling method.

	Press the off-hook key.
	The following appears on the
	display "" .

DIAL MODE

3PULSE

or

TONE

Open the menu.

Confirm.

Select and confirm your desired signaling method

select and confirm. Press the on-hook key.

8If you hold down the 4key, you automati- cally have multifrequency signaling for the subsequent call.

Flash times („R key“)

This function allows you to change the set flash time (factory default see page 20).

3TBR

3180 MS

Press the off-hook key.

Open the menu.

Select and confirm.

Select and confirm the desired flash time (80, 100, 120, 180, 250, 300 or 600 ms).

Press the on-hook key.

18

Image 18

Contents Be inspired User guideDisplay symbols and special characters Brief overview of the handsetCongratulations Safety information Use only the plug-in power supply unitContents Connect up the base unit For the analog landline networkPut the handset into operation Inserting the batteriesUse only approved, rechargeable batter Place the handset on Base unit Charge the batteriesRecommended batteries Operating times/charging timesAccepting a call Making a phone callCalling RedialingDisplaying the callers number Clip Activating/deactivating the key lockStoring a new entry Using the phone book to dialPhone book Changing an entryRegistering the handset with the base unit StepConfirm your entry Receiver volume Settings of the handsetVolumes and tunes Ringing tone volumeResetting the handset to the factory defaults Changing the display languageFactory defaults of the handset Function Flash times „R key Settings of the base unitSignaling method PrerequisitePulse/no-pulse ratio Resetting the base unit to the factory defaults Factory defaults of the base unit FunctionAppendix TroubleshootingProblem Possible Solution Cause Caring for your phoneGuarantee RangeSiemens Limited, ICM Fitzwilliam Court, Leeson Close Dublin Kingdom ServiceUnited IrelandSettings of the handset Menu overviewExamples Settings of the base unit Index New entry phone book 12 Number, see call number

Related manuals

Manual 282 pages 42.81 Kb