Siemens 200 manual Put the handset into operation, Inserting the batteries

Page 7

Gigaset 200, GBR, A31008-G200-B101-1-7619

VORBEREI.FM

28.09.01

●Use only the plug-in power supply unit

!provided, as indicated on the bottom of the base unit.

●Important: new phone cable. Use only the enclosed cable type.

●If you purchase another cable, ensure that it has the correct connector pin assignment.

Step 2: Put the handset into operation

The display is protected by a plastic foil.

Please remove the protective foil.

Inserting the batteries

+	+
–	–
–	–
+	+

●Insert the batteries with the correct polarity – see figure.

●Put the lower end of the battery compartment cover in position (see arrow), and press against the _ribbing at the top until it engages.

●To open it, lift the cover by the ribbing.

●Use only approved, rechargeable batter-

!ies of the same type. Otherwise you risk damaging your health and the product.

●Do not use charging units belonging to other devices because they could damage

the batteries.

7

Image 7

Contents User guide Be inspiredBrief overview of the handset Display symbols and special charactersCongratulations Use only the plug-in power supply unit Safety informationContents For the analog landline network Connect up the base unitInserting the batteries Put the handset into operationUse only approved, rechargeable batter Charge the batteries Place the handset on Base unitOperating times/charging times Recommended batteriesRedialing Making a phone callCalling Accepting a callActivating/deactivating the key lock Displaying the callers number ClipChanging an entry Using the phone book to dialPhone book Storing a new entryStep Registering the handset with the base unitConfirm your entry Ringing tone volume Settings of the handsetVolumes and tunes Receiver volumeChanging the display language Resetting the handset to the factory defaultsFactory defaults of the handset Function Prerequisite Settings of the base unitSignaling method Flash times „R keyPulse/no-pulse ratio Factory defaults of the base unit Function Resetting the base unit to the factory defaultsCaring for your phone TroubleshootingProblem Possible Solution Cause AppendixRange GuaranteeSiemens Limited, ICM Fitzwilliam Court, Leeson Close Dublin Ireland ServiceUnited KingdomMenu overview Settings of the handsetExamples Settings of the base unit Index New entry phone book 12 Number, see call number

Related manuals

Manual 282 pages 42.81 Kb