BT Diverse 2000 user manual No display appears

Page 54

If you have a problem, the following simple solutions may provide the answer.

No display appears

Is the handset switched on? The battery may be flat or dead. Recharge or replace the battery.

No dial tone

Is the telephone line cord plugged into the phone socket and the base station?

If other handsets are registered on the base, the outside line may already be in use. Wait until the call is finished and try again.

‘Search station’ is flashing on the display or you can not link up with the base station

Is the handset registered with the base station? To register the handset, see page 12.

Is the power cable connected at the base and power switched on at the wall socket?

Is the handset within range of a base station to which it is registered.

Please note: If you go out of range of

a base station for a long time while your handset is switched ON, it may take more than 20 minutes to ÔfindÕ the base station again when you come back within range. However, by simply switching the handset OFF for a moment, and then ON again, it will find the base station within a few seconds.

52

Image 54

Contents Diverse 2000 Executive Handset user guide See page 33 for more information about your handset PIN At a glance DisplayPage This guide Introduction Page General cleaning Approved rechargeable batteries Setting Up Install the rechargeable batteries in the handsetFit the handset belt clip Charge the handset batteries for at least 16 hoursBattery performance Getting the most out of your batteries Internal Redial At the base station Press the PWR button. The display shows Register Base Settings Service Using Diverse Executive Handset On/Off and Protected modesMaking and receiving external calls Phone rings and the display shows Paging and making calls between handsets Recall Using the Phone Book To dial a number stored in the phone book Delete Entry Settings Enter PINHandset Volume Highlight Ringer Options using Down optionRinger Volume or Ringer Tone To adjust the ringer volume Handset SettingsTo switch on and remove advisory beeps and warnings Select Handset Settings Select Handset Settings Select Auto BacklightSelect Handset Settings Select Auto Talk If you accidentally set the wrong language Select Handset Settings Select Babyalarm Level Additional features Call timerSecurity Settings Operating with additional base stations BestSelect Base Settings Select Priority SelectionChange Base Name Select DE-REGISTER Base Baby Alarm Call Barring Select Handset LockShort Cuts Short Cuts Copied To create a new short cut Adding short code functions Function table Function DisplayOFF Viewing Then ENTRIES? Maintenance ServiceIf you have to return your Diverse 2000 Executive Handset Help Replacing handset batteries No display appears Page Technical information Connecting to switchboards Index PIN Page Offices in Europe, North America, Japan and Asia Pacific