Clarity C600 manual Adding the Emergency Number, Dialing the Emergency Number

Page 20

Memory Storage

Press DEL/CH key to move the cursor back to character C.Then press any other numeric key to change this character.

10.Press ENTER to finish.The modified characters and numbers will replace the original phone record.

11.The display will show NUMBER STORED.

Adding the EMERGENCY Number

1.Unit must be in standby mode only.

2.Press MODE key twice.The display will show PHONEBOOK for 1 second and then display the first available record.

3.Press the UP(▲) or DOWN (▼) button to go to the record to be stored to the EMERGENCY key.

4.Press and hold the EMERGENCY key for 2 seconds.

5.The phone number is copied to the EMERGENCY key.The LCD will display MEM STORING for one (1) second and the handset will give a success keynote.

Dialing the EMERGENCY Number

1.Unit must be in standby mode only.

2.Press the EMERGENCY key once.

3.The display will show the stored name and number for 5 seconds. Otherwise it will show -MEMORYEMPTY-.

4.Then the handset goes off-hook and dial out the stored numbers.

Or

5.Press TALK key to make handset goes off-hook.

6.Press the EMERGENCY key once.The display will show the stored name and number for 1 sec.Then the numbers will be sent out.

Deleting the EMERGENCY Number

1.Unit must be in standby mode.

2.Press the EMERGENCY key once.

3.If this key has been programmed, the display will show the stored number. Otherwise, it will show MEMORY EMPTY.

4.Press DEL/CH key once to delete this number.

5.The display will flash DELETE ?.

20

Image 20

Contents GHz Cordless Telephone with Caller ID Table of Contents Important Safety Instructions Read and understand all instructionsSafety Instructions For Batteries Never install telephone wiring during a lightning stormUse caution when installing or modifying telephone lines Designed for wet locationsFeatures DEL/Channel Button DEL/CH Volume Control Talk Button TalkMm Headset Jack Key Pad Neckloop Jack Handset Charging ContactsTelephone Base Base Side/End/Bottom Installation Connecting Your TelephoneTable/Desktop Installation Getting StartedPlace handset in the cradle to begin initial charging Wall Mounting InstructionsLift the bases antenna to a vertical position Battery Installation To Install a New BatteryHandset Battery Charging Low BatteryHearing Aid Compatibility Headset JackBelt Clip Feature Set-up Caller ID DisplaySetting LDS Code Setting Easy ModeSetting Voicemail no Setting Message Waiting ON/OFFTelephone Base Boost ON/OFF Switch Battery BackupPulse/Tone FlashTelephone Operations Temporary Tone Lighted Key Pad Page/Handset Locator Channel OperationMemory Storage Memory OperationsReview Phonebook Information Adding a Phonebook NumberDialing a Phonebook Entry Deleting a Stored NumberDeleting All Stored Numbers No actionDeleting the Emergency Number Adding the Emergency NumberDialing the Emergency Number Caller ID Information Visual Message Waiting Indicator VmwiCaller ID Operations Saving Caller ID Information to Phonebook Callback from Caller IDInformation Digits without a 1 prefixArea Code + 7 digits without a 1 prefix Digits with a 1 prefixDeleting All Caller ID Information Delete Caller ID InformationDelete One Caller ID Information Maintenance and Care Avoid dropping or knocking the unitTroubleshooting Phone does not ring when you receive a callUnit will not operate/no dial tone Few devicesPhone Will Not Hold Charge Difficulty in Placing or Receiving CallsRegulatory Compliance Part 68 of FCC Rules InformationCustomer-Owned Coin/Credit Card Phones Part 15 of FCC Rules InformationIndustry Canada Technical Specifications EquipmentWarranty and Service How to Obtain Warranty Service United StatesCanada Fax 514