MPH-4385 (REVISED2/01).O/M.QXD 6/20/01 7:41 AM Page 5
INSTALLATION
This unit can be used on a desk, or other level surface or mounted on the wall away from excessive heat or direct sunlight.
TO TELEPHONE BASE
Desk or Table Use
1.Set the RINGER switch to LO or HI to have the ringer sound when receiving a phone call.
2.Set the TONE/PULSE switch to TONE or PULSE to match the service provided on your telephone line. If you are not sure of your service, please contact your telephone company.
3.Connect the coiled cord to the handset and base. Connect the straight cord to the base and telephone jack as shown in Figure 1.
TELEPHONE LINE CORD
Figure 1
Wall Mounting
1. | Attach the supplied Wall Mount adapter to the rear of the |
|
| telephone. |
|
2. | Drill two holes with a vertical distance between the two |
|
| marked positions of 83mm as shown in Figure 2. | 83mm |
3.Drive a screw into each of the holes. Tighten them to the end of the screw lines, only leaving the smooth part of the
screw head outside the wall.
4.Plug the telephone line cord into the modular wall jack.
5.Reverse the position of the Wall Mount Hook on the base
as shown in Figures 3 and 4.
6.Hang the unit onto the screws, then slide it down firmly to fasten the base securely.
7.When using this phone as a wall mount phone, be sure to route the short line cord on the back of
the base unit and plug the other end into the wall mount jack.
Figure 3 | Figure 4 |
|