4.When the other handset answers by pressing 
/FLASH
or /SPEAKER, press 
/BACK to transfer the call. If the other handset does not answer, press 
/ MUTE to talk to your caller again.
3.14.3Three-party conference call
1. During an external call, press INT. - Your caller is put on hold.
2. Press VOL+ or REDIAL/VOL- to select the handset you want to call.
3. Press MENU to call the handset.
4. When the other handset answers the intercom call, press MENU on the calling handset to set up the conference call.
5. Press 
/BACK on any handset to end a
NOTE
During an external call, pressing 
/FLASH or / SPEAKER on any handset will join in the call and set up a conference call.
3.15Setting the dial mode
The default dialing mode is suitable for your country and network operator. It is unlikely that you should need to change this setting unless advised to do so.
1.Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS.
2.Press MENU to select DIAL MODE.
3.Press MENU and then VOL+ or REDIAL/VOL- to select
TONE or PULSE.
4.Press MENU to save.
NOTE
If the pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily when dialing out. After the call is ended, the dial mode will change back to pulse.
3.16Setting the flash time
The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so.
1.Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS.
20 | Using the phone |
|
|