NOTE
If you switch Easy call on, EASY CALL ON will be displayed on your screen in standby mode.
To switch Easy call off again:
1.Press >.
2.OFF? is displayed. Press mto confirm.
Set the easy call number
1.Press m, scroll dto ADVANCED SET and press m.
2.Scroll dto EASY CALL. Press m.
3.Enter the master PIN (Default setting 0000) and press m.
4.Scroll dto NUMBER. Press m.
5.Enter the number. Press mto confirm
6.Press >to return to standby.
Dial an easy number
When an easy call number has been stored and the easy call setting switched on, press any key (apart from >), to dial a number.
NOTE
When easy call is switched on, you can still answer any incoming call as normal.
Registration
Up to 5 handsets can be registered to one base station. Additional handsets must be registered to the base before you can use them.
•The instructions described below apply specifically to your D1011 handset. If you wish to register another manufacturer’s handset, the instructions may vary. In this case, please refer to the manufacturer of the additional handset.
•The Master PIN is required before you can register or unregister handsets. The default PIN is 0000.
Register a handset
At the base:
1.Press and hold the pbutton on the base station for at least 3 seconds. The base station emits a beep when it is ready to accept registration. You have 90 seconds in which to register a handset.
At the handset:
1.Press mand scroll dto ADVANCED SET and press m.
2.Scroll dto REGISTRATION and press m.
3.If necessary, scroll uor d to display REGIST. BASE and press m. BASE 1 2 3 4 is displayed and the registered base number is flashing. Enter the number of the base on which you wish to register your handset.
If you have only 1 base station, press 1. If you have 2 base stations, press 1or 2, etc.
4.When the display shows
-When the handset registers with the base, it is assigned a handset number.
Select a base
You can register your D1011 handset with up to 4 bases. Once registered, you can switch between bases, for example, bases at home and at work.
1.Press mand scroll dto ADVANCED SET and press m.
2.Scroll dto REGISTRATION and press m.
3.SELECT BASE is displayed. Press m.
-The available bases are displayed with the current base number flashing.
4.Enter the number of the base you want – 1,2,3 or 4 and press m.
-When the base is found you hear a beep. If not found, the display
shows UNREGISTERED.
Unregister a handset
1.Press mand scroll dto ADVANCED SET and press m.
2.Scroll dto UNREGISTER and press m.
Advanced settings | 23 |
|
|