SpectraLink 72-1084-02 manual Do not Power

SpectraLink Corporation		Setup and Administration—NetLink e340/i640 Wireless Telephone
		Mitel Networks ICP and 5220 IP Phone emulation
Message		Description	Action
DO NOT POWER	The Wireless Telephone is in a		None. Do not remove the battery
OFF	critical section of the software		or attempt to power off the phone
	update.		while this is displayed. Doing so
			may require the phone to be
			returned to SpectraLink to be
			recovered.
Duplicate IP	The Wireless Telephone has		If using DHCP, check that the
	detected another device with its		DHCP server is properly
	same IP Address.		configured to avoid duplicate
			addresses.
			If using Static IP, check that the
			Wireless Telephone was assigned
			a unique address.
Erase Failed	Download process failed to erase the		Operation will retry but may
	memory in the Wireless Telephone.		eventually report the error "int.
			error: 0F" Power cycle the phone.
Erasing Memory	Wireless Telephone has determined		None. When the progress bar fills
	that a download should occur and is		the display line the erase operation
	erasing the current software from		is complete.
	memory.
Initializing …	The Wireless Telephone is		None. This is informational only.
	performing power on initialization.
Internal Err. # #	The Wireless Telephone has		Record the error code so it can be
	detected a fault from which it cannot		reported.
	recover.		Turn the Wireless Telephone off
			then on again.
			If error persists, try registering a
			different Wireless Telephone to
			this telephone port.
			If error still persists, contact
			SpectraLink Technical Support and
			report the error.
Network Busy	All APs are full or busy.		Try call again later.
No Host IP	The Wireless Telephone is		Enter a valid IP Address in the
	configured for “static IP” (as opposed		configuration settings or change to
	to “use DHCP”) and no valid host IP		“use DHCP”.
	Address (the Wireless Telephone’s
	IP Address) has been entered.
No IP Address	Invalid IP.		Check the IP Address of the
			Wireless Telephone and re-
			configure if required.
No PBX Response	The Wireless Telephone tried to		Verify the supported Mitel
	send a message to the supported		Networks VoIP solution is
	Mitel Networks VoIP solution and		operational and connected to the
	failed to get a response.		network.

PN: 72-1084-02-B.doc Page 38