Telular SX5D GSM technical manual Digital Data Service, Standard Modem Setting, PC Data Connection

DIGITAL DATA SERVICE

To PC Serial Port	DB-9 cable and PC serial
	port have 9 PIN connections

DB-9 (female) to DB-9 (male) Cable

OR

DB-25 cable and PC

serial port have 25To DB-9 Data Port PIN connections

DB-25 (female) to DB-9 (male) Cable

Figure - PC Data Connection.

Standard Modem Setting

The SX5D features a DB-9 digital computer fax/data port for connection to a personal computer (PC) - not supplied. When connected to a PC, the SX5D’s PC interface is capable of sending and receiving digital fax transmissions, sending and receiving e-mail communications, and browsing the Internet (Data speeds may vary depending upon your cellular network).

PC Data Connection

A data cable - not included - is required for data transmission. To determine the necessary cable, count the number of PIN connections in the serial port of your PC (see below). If there are 9 PIN connections in the PC serial port, a DB-9 (female) to DB-9 (male) cable is required. If there are 25 PIN connections in the PC serial port, a DB-25 (female) to DB-9 (male) cable is required - see

Figure - .

For specific digital fax/data setup procedures, see Appendix A - Setup PC Serial Port for Phonecell Digital Fax/Data.

Sending and Receiving Digital Fax

Your computer needs a standard 19,200 bps modem and a commercial PC fax emulator (Winfax, Netfax, etc.), To send a fax, no special settings are required. The computer will change the SX5D mode setting automatically and reset it to voice mode after sending a fax. To receive a fax, you must change the SX5D from voice to fax mode.

1)Set up a standard 19,200 bps modem.

2)Install a commercial PC fax emulator (Winfax, Netfax, etc.).

Phonecell® SX5D GSM 31 Technical Manual