Emergency (EMG) Call Button Button (14)
This radio has a quick access button (EMG) to the Emergency and Assistance Channel. This channel is not monitored by local authorities. When using this channel, EMG appears on the display. Pressing this button will set the transceiver to the channel 10, 462.6750 MHz).
External Speaker (SPK)/Microphone (MIC) Jacks (6)
This set of jacks accepts an Audiovox headset/microphone connector.
Scan/Lock Button (13)
Press this Button momentarily to enable or disable the scan mode. Press and hold Button for more than 1 second to lock or unlock the key pad, except PTT and Monitor (M). When the keypad the ( 
) icon will display in the top right corner.
Operating Modes and Features
GRMS Operation
-From GMRS standby mode, press and hold the ( 
) button for 2 seconds to turn on power.
-Press the MODE button so the Channel number flashes.
-Select the desired channel with the Up (10) and Down (11) Buttons. When receiving a call, the signal strength meter appears to indicate incoming received signal strength and the Monitor section of the Transmit/Monitor LED (16) lights green.
-Press and hold the PTT button (4) to transmit, then speak into the microphone clearly and slowly. The Transmit section of the Trans- mit/Monitor LED (16) lights red.
-Release PTT Button (4) to receive.
-Communication can only be accomplished when the channel and CTCSS tone frequency of at least two parties are the same.
-The CTC icon will be displayed on the LCD panel if the CTCSS tone frequency function is enabled.
10