Walker W1100 Operating the Walker Clarity, Neck Loop/Auxillary Port, To Place or Receive a Call

Page 16

OPERATING THE WALKER CLARITY®

➤Neck Loop/Auxillary Port

The W-1100 has a 3.5mm phono jack to use with a neck loop. The volume to the neck loop is controlled with the Clarity Power Control. When the neck loop is plugged in, the receiver in the handset is disabled.

Once you have installed your Walker Clarity according to the instructions noted previously, it will be ready to use.

➤To Place or Receive a Call:

1.Adjust the Clarity Control to its lowest setting (zero).

2.Pick up the handset and listen for the caller’s voice or a dial tone. Watch the green sound level light located on the phone base, next to the program button. It should sign steady.

3.When placing a call, dial as you would any phone and wait for someone to answer.

4.Press the Boost Button

5.Adjust the Clarity Power Control up- wards to a level where the other party’s voice is heard loud and clear, and begin conversation.

6.When you complete the call, return the handset to the base unit.

7.After hanging up, the sound level will reset to normal level.

8.Pressing the Boost Button during subsequent conversations will return the volume to your set sound level.

Note: If you made an error while dialing, just depress the hookswitch, listen for a dial tone, and dial again.

16

W-1100 Clarity Extra

Page 15 Page 17
Image 16
Page 15 Page 17
Contents ClarityExtra Table of Contents Important Safety Instructions Safety InstructionsRead and Understand All Instructions Clarity Extra Safety Instructions Unpacking the Walker Clarity Inside you will find the following itemsConnecting the Clarity Phone InstallationSelect a Location Installation View RJ-11CDesk Mount key Wall Key Back Phone Wall Mount BracketHook Switch Tabs Walker Clarity Features Clarity Power Control To Increase Clarity PowerTo Decrease Clarity Power Clarity Effect On/Off Switch Smart Tone Control Walker Clarityfeatures Ringer Controls Visual Ringer Warble Control For Low Frequency Loud RingTo Set the TONE/PULSE Switch To Use the Flash FeatureLast Number Redial To Operate Last Number RedialTo Use the Hold Feature HoldMute Surge ProtectionNeck Loop/Auxillary Port Operating the Walker ClarityTo Place or Receive a Call Programming Numbers Into Memory To Program Numbers into the Clarity PhoneProgramming To Dial Programmed NumbersCare Programming Problems Can’t Store Numbers Into Memory TROUBLE-SHOOTING GuidePhone Doesn’t Dial Out On First Attempt G L I S Ringer Volume Problem Unable To Hear Phone Ringer Federal Communications Commission Requirements Connection and use with the nationwide telephone networkNotification to the telephone company Repair InstructionsPart 15 of FCC Rules Interference Information Walker Equipment Limited Warranty Walker Warranty Service Hearing Aid CompatibilityWalker Service Out-of-Warranty Service
Top Page Image Contents