Walker W1100 manual G L I S

Page 21

TROUBLE-SHOOTING GUIDE

Static On Line

Feedback Problems.

 

• Interference From

•Ê Feedback Occurs When

Handset Is Set Down

Household Appliances

 

E N G L I S

—Your Clarity phone may be located near a touch lamp, microwave or refrigerator which may cause interference. Relocating your phone to another area may eliminate the problem.

—A cordless phone on your phone line may also cause static. Try disconnecting your cordless phone for several days. This may eliminate the problem.

Disconnect any extra devices which may be attached to the phone. Extra devices may include cord detangler’s, caller ID units, and answering machines.

•Ê Interference From Malfunctioning, Frayed Or Poorly Connected Telephone Cords

—Check your phone cords and connec- tions. Try interchanging cords with another phone to see if the problem is eliminated. Replace any defective equipment.

—Avoid setting receiver on a hard surface or attach a foam receiver pad to earpiece of phone. You can also lay the receiver on its side. This will eliminate feedback also.

Transmission Problems

•Ê The Person On The Other End Cannot Hear You

—Too many phones or phone devices on the line may effect your phone’s transmis- sion. As a guideline, more than five (5) phones or phone devices may overload the phone line. Disconnect one (1) or two

(2)of the devices to see if that eliminates the problem. If not, contact your local phone company for load guidelines.

—You may not be speaking directly into the transmitter. Always speak directly into the mouthpiece in your normal tone of voice.

H

21

Image 21
Contents ClarityExtra Table of Contents Safety Instructions Important Safety InstructionsRead and Understand All Instructions Clarity Extra Safety Instructions Inside you will find the following items Unpacking the Walker ClarityInstallation Connecting the Clarity PhoneSelect a Location RJ-11C Installation ViewWall Mount Bracket Desk Mount key Wall Key Back PhoneHook Switch Tabs Walker Clarity Features To Increase Clarity Power Clarity Power ControlTo Decrease Clarity Power Clarity Effect On/Off Switch Smart Tone ControlRinger Controls Visual Ringer Walker ClarityfeaturesWarble Control For Low Frequency Loud RingTo Use the Flash Feature To Set the TONE/PULSE SwitchLast Number Redial To Operate Last Number RedialHold To Use the Hold FeatureMute Surge ProtectionOperating the Walker Clarity Neck Loop/Auxillary PortTo Place or Receive a Call To Program Numbers into the Clarity Phone Programming Numbers Into Memory To Dial Programmed Numbers ProgrammingCare TROUBLE-SHOOTING Guide Programming Problems Can’t Store Numbers Into MemoryPhone Doesn’t Dial Out On First Attempt G L I S Ringer Volume Problem Unable To Hear Phone Ringer Connection and use with the nationwide telephone network Federal Communications Commission RequirementsNotification to the telephone company Repair InstructionsPart 15 of FCC Rules Interference Information Walker Equipment Limited Warranty Hearing Aid Compatibility Walker Warranty ServiceOut-of-Warranty Service Walker Service