Shiro SD2100 user manual Making and answering calls

the base unit from the telephone line and the mains socket when there are storms in your area. Damage caused by lightning is not covered by the Guarantee.

4.The SD2100 will produce a certain amount of heat during operation. For this reason it is

recommended that this equipment is NOT placed in direct contact with antique, veneered or delicate furniture surfaces.

5.DO NOT dispose batteries with normal household waste.

6.The SD2100 DECT phone emits radio signals which could interfere with other electronic equipment, computers, radio, TV set, clock radio alarms, etc.

A distance of at least one meter should be maintained between SD2100 base station and other equipment. This will minimize the risk of such interference.

7.When you do not need to carry your handsets around, leave them on the base unit or charger pod, to keep the batteries charged.

8.If you hear a warning tone as move around during a call, and/ or the sound in the earpiece becomes faint or distorted; you may be going out of range of the base unit.

Move nearer to the base unit within 20 seconds, until the tone stops. Otherwise your call may be cut off.

!NOTE: Dispose of used batteries safely, never burn them, or put them where they could get punctured.

Making and answering calls

To switch the handset ON or OFF

•Press and hold the CLEAR button for 2~3 seconds to switch the handset ON /OFF.

To make a call

1.Key in the telephone number (If you make a mistake, press CLEAR button to clear digits from the display. To clear all digits, press and hold CLEAR button.)

2.Press the CALL button.

3.Or you also can dial the stored number through UP/DOWN button.

Note: You can dial the number after you press the CALL button if you need, but you won't be able to correct any mistakes if you do it in this way.

When you dial the outside line access digit (e.g. 9) then the telephone number, press and hold the "#" button about 2 seconds for a pause.

To redial a call

In standby mode, press and hold the CALL button to enter the dial list, and press the UP/DOWN button to scroll through the number you want to dial, then press the CALL button to redial.

To answer a call

When the handset and base unit ring, press the CALL button to answer a call, and the symbol or appears in the display.

When the AUTO TALK is turned on, you can simply answer the call by lifting the handset from the base unit (see AUTO TALK part).

To end a call

Press the END button to end a call.

Earpiece volume

During a call, to adjust the volume of the earpiece:

Press the UP or DOWN button to change the volume

Muting the mouthpiece

•During a call, if you want the person on the other hand end cannot hear you; press Mute once to mute the mouthpiece;

5