Sanyo CLT-D6620(WH), CLT-D6622 Multi Handsets Functions, Registration, To register a new handset

MULTI HANDSETS FUNCTIONS

If you have more than one handset, you can enjoy an intercom call between handsets. You can also establish a conference call (between two handsets and outside).

Registration

The handset and base unit are factory pre-registered with each other. Therefore, the unit should be in full working order out of the box. When you purchase an additional handset, you have to register it to the base unit in order to make and answer calls.

You can register up to 3 more handsets to make and answer calls via the same base unit. Handsets are numbered 1 to 4.

If your handset is not registered to the base "NOT REGISTERED" will display on the handset. The handset must first be registered to the base to be used.

To register a new handset:

1.Touch and select the SECURITY SET menu and then the

REGISTRATION submenu.

2.Use or to select the base number you wish to register to.

3.Touch to confirm.

4.Enter the 4 digit PIN code (default 0000) and touch , you will see the message: 'REGISTERING'.

5.Press and hold the PAGE key on the base until the Charge/In use LED flashes.

6.‘REGISTRATION ACCEPTED’ indicates that handset is registered.

‘RETRY?’ indicates that registration has failed. Touch to retry or to quit.

To select a base unit on your handset:

Your telephone supports up to 4 base units. After you register 1 handset to 4 base units, bases are numbered 1 to 4, you may select which one to use.

1.Touch and select the SECURITY SET menu and then the SELECT

BASE submenu.

2.Use or to select the base number or ‘AUTO’ (automatically selects the nearest base).

3.Touch to confirm.

4.‘ACCEPTED’ indicates that base has been selected. ‘RETRY?’ indicates

that selection has failed. Touch to retry or to quit.

30