Sanyo CLT-D5880 Additional Information, Changing the Digital Security Code, Find Handset

UP800DH(CLT-D5880) OM 1/24/06 3:39 PM Page 49

ADDITIONAL INFORMATION

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary. In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code. To change the digital security code:

1 In standby mode, select Deregister HS in the menu and press the OK soft key. Deregister HS? appears.

2 Press VOL/▲ to select Yes and then the OK soft key.

When de-registration is complete you will hear a confirmation tone, and Deregistration Complete appears.

3 After de-registering the handset, place the handset to the base to register. You must re-register the handset before you can use it.

Find Handset

To locate the handset, press PAGE on the base when the phone is in standby mode. All registered handsets beep for 60 seconds, and Paging appears on the handset display. To cancel paging, press any key on the handset or PAGE on the base.

Note:

• If the battery pack is completely drained, the handset will not beep when paging.

E49