Troubleshooting
The phone does | I cannot hear the tone | The morning call/alarm | |
not work at all. | when I press | button. | does not work. |
●Is the phone correctly installed? | ●Check if the phone is correctly | ●Check if the current time is | |
(Refer to page 9) | connected. |
| accurately set. |
●Is the power correctly connected | (Refer to page 9) |
| (Refer to page 15) |
to the appropriate voltage? | ●Check if the power is correctly | ●Check if the morning call | |
(Refer to page 9) | connected. |
| time is set. |
●Check if the batteries are | (Refer to page 9) |
| (Refer to page 22) |
correctly inserted to the remote |
|
| ●Check if the morning call/alarm |
set. (Refer to page 10) |
|
| function is set. |
●Check if the batteries are |
|
| (Refer to page 22) |
adequately charged. |
|
|
|
(Refer to page 10) ●Check if the power is on.
(Refer to page 9)
I hear many noises while
using the remote set.
●Press 
button to reduce the noise.
(Refer to page 31)
●Check if the distance is too far from the base set.
(Refer to page 31)
●Try installing the base set at a different location.
I hear beeping warning sounds in the remote set.
●Check if the base set is currently in use. Try again after the call in the base set has been hung up.
●Check to see if you are too far away from the base set. If yes, move closer toward the base set. (Refer to page 31)
●If you see the 
mark on the screen, hang up the phone and adequately charge your remote set.
(Refer to page 31)
Internal or transferring calls are not working.
●Check if you have installed the phone correctly.
(Refer to page 9)
●Try
(Refer to page 33)
The phone does not ring in the
base set or the remote set.
●Check if the batteries are correctly inserted. (Refer to page 10)
●Check if the batteries are adequately charged. (Refer to page 10)
●Check if the power of the remote set is on. (Refer to page 9)
●Try
(Refer to page 33) ●Check if the BELL OFF is
selected. (Refer to page 21)
I cannot recharge
the remote set.
●Check if the charging connector is clean.
●If the charging connector is not clean, use a cotton tip or an eraser to wipe it clean.
(Refer to page 37)
●Check if the power voltage is appropriate. (Refer to page 9)
●If you have cleaned the charging connector but it still does not work, then please contact your local service center and purchase new batteries.
(Refer to page 10)
● When there is a problem with radio communication between the base set and the remote set, do the following, and if it still will not work, then please contact your local Samsung Electronics Service Center.
● Follow instructions in the order.
Base | � | � | � | � |
Set | ||||
Remote | � | � | � | � |
Set |
※See page 33 for registering a remote set
Reference
35 | 36 |