USER’S MANUAL
VTECH 9 1 0 / 9 1 5 A D L
900MHzANALOGCORDLESSTELEPHONE
INTRODUCTION
Parts Check List:
1.Handset
2.Base Unit
3.Telephone line cord
4.AC adapter
5.Battery Pack
6.Wall mounting bracket
IN USE |
| BATT |
| LOW | |
PHONE | CHAN | OFF |
1 | 2 ABC | 3 DEF |
4 GHI | 5 JKL | 6 MNO |
7PQRS | 8 TUV | 9WXYZ |
TONE 0OPER #
PROG MEM REDIAL
ME | MORY |
|
|
|
| DIAL |
|
| |
|
|
|
| |
|
| ING |
|
|
| • | • |
|
|
• |
|
|
| |
• |
|
|
|
|
• |
|
|
|
|
|
|
| IN | POWER |
|
|
| CHARGE | USE |
|
| SPARE |
| |
|
| BATT |
| |
|
|
|
| |
|
| PAGE |
|
|
HANDSET | BASE UNIT |
TELEPHONE LINE | AC ADAPTER |
CORD |
|
IMPORTANT
BEFORE USING YOUR NEW PHONE, WE
STRONGLY RECOMMEND YOU READ THIS
MANUAL THOROUGHLY.
VTECH COMMUNICATIONS LTD.
Copyright 1997 for VTECH COMMUNICATIONS LTD.
Printed in China. ISSUE 0
BATTERY PACK | WALL MOUNT BRACKET |
IMPORTANT SAFETY INSTRUCTIONS
REPLACING THE HANDSET BATTERIES
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following:
1. R e a d a n d u n d e r s t a n d a l l instructions.
2.Follow all warnings and instructions marked on the product.
3.Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4.Do not use this product near water (for example, near a bath tub, kitchen sink, or swimming pool).
5.Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.
6.Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect it from overheating, these openings must not be blocked by placing the product on the bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a
7.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your dealer or local power company.
8.Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking on it.
9.Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage
points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.
10.To reduce the risk of electric shock, do not disassemble this product. If service or repair work is required, contact VTech Customer Service at
11.Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.
12.Unplug this product from the wall outlet:
a)When the power supply cord or plug is damaged or frayed.
b)If liquid has been spilled into the product.
c)If the product has been exposed to rain or water.
d)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions because improper adjustment of other controls may result in damage and will often require extensive work to restore the product to normal operation.
e)If the product has been dropped and the cabinet has been damaged.
f)If the product exhibits a distinct change in performance.
13.Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lighting.
14.Do not use the telephone to report a gas leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS
1.Remove the battery case by pressing on the ridged lines and sliding downward.
2.Discard the old battery pack. Don't put the old battery pack in a trash compactor or a fire - it could burst.
IMPORTANT: Do not dispose of this battery in h o u s e h o l d g a r b a g e . F o r information on recycling or proper disposal, consult your local solid waste collection or disposal organization.
3.Place the new battery pack in the battery compartment. Make sure the metal contacts on the underside of the battery are aligned with charging contacts in battery compartment.
4.Replace the battery cover by sliding it into place.
5.The new battery pack must be charged before using your telephone. Place the handset in the cradle of the base unit to allow it to charge for 24 hours. Maximum battery life between charges is more than 7 hours of continuous talk time or 6 days of standby.
CAUTION: To reduce the Risk of Fire or Injury to Persons, Read and Follow these instructions:
1.Use only VTECH battery.
2.Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.
3.Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause burns.
4.Do not dispose of the battery in a fire. The cell may explode.
SPARE BATTERY CHARGER
Your VTech 910 ADL is equipped with a spare battery charger
Contact your local VTech dealer, or call VTech Customer Service to purchase a spare battery pack.
To install the Spare Battery Pack (NOT INCLUDED):
1. O p e n t h e b a s e u n i t b a t t e r y compartment.
2.Place the spare battery pack in the battery compartment. Make sure the metal contacts on the underside of the battery are aligned with charging contacts in battery compartment.
3.Replace the battery compartment cover.
4.When the battery is installed properly, the spare battery LED on the base unit will be illuminated.
5.The spare battery will be fully charged after 24 hrs. Please note that the spare battery LED will always be illuminated when a spare battery is installed.