VTech VT 9123 Case of Difficulty, Phone DOESN’T Work AT ALL, No Dial Tone, Vtech Electronics at

Page 21

IN CASE OF DIFFICULTY

If you have difficulty operating your phone, the suggestions below should solve the problem. If you still have difficulty after trying these suggestions,

In the US call:

VTECH COMMUNICATIONS at 1-800-595-9511.

In Canada call:

VTECH ELECTRONICS at 1-800-267-7377.

THE PHONE DOESN’T WORK AT ALL.

•Make sure the power cord is plugged in.

•Make sure the telephone line cord is plugged firmly into the base unit and the telephone wall jack.

• Make sure the batteries are properly charged. If the Battery Low indicator is on, the battery needs charging. If the LCD display shows “NEEDS RECHARGING” : you must charge the batteries.

•If you recently installed a new battery pack, make sure it is installed correctly.

NO DIAL TONE.

•First check all the suggestions above.

•If you still don’t hear a dial tone, disconnect the base unit from the telephone jack and connect a different phone. If there is no dial tone on that phone either, the problem is in your wiring or local service. Call your local telephone company.

YOU GET NOISE, STATIC, OR A WEAK SIGNAL EVEN WHEN YOU’RE NEAR THE BASE UNIT.

•Place the handset in the base momentarily to re-set the unit. Then press PHONE to get a line.

•Household appliances plugged into the same circuit as the base unit can sometimes cause interference. Try moving the appliance or the base unit to another outlet.

YOU GET NOISE, STATIC, OR A WEAK SIGNAL WHEN YOU’RE AWAY FROM THE BASE UNIT.

•You may be out of range. Either move close to the base, or relocate the base unit.

•The layout of your home may be limiting the range. Try moving the base unit to the second or third floor, or to some other location.

ADDITIONAL INFORMATION

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Table of Contents Important Safety Instructions Telephone Cord Parts Check ListDialing Keys Handset LayoutBase Layout Installation of Battery Pack in Handset To purchase replacement battery packs, call VTech atFollow the Instructions Setting UP Your VT 9123/9126 Ringer SelectionTONE/PULSE Selection Wall Mounting Handset is in idle mode Handset DisplayIf the display says It means Basic Operation Volume ControlMaking Calls MethodUsing Redial Answering CallsFlash Hold Receiving and Storing Calls Caller ID/CALL Waiting IDAbout Call History Review Caller IDDeleting Records from Call History Dial a Displayed NumberStore a Caller ID Record in Phone Book Memory Caller’s name Display Screen MessagesCaller’s number ErrStore Memory Numbers Phone BookEdit Numbers Stored in Memory Delete Numbers Stored in MemoryDial Memory Numbers Until Messages Waiting is Messages WaitingInstallation OperationBelt Clip Maintenance Phone DOESN’T Work AT ALL Case of DifficultyNo Dial Tone Vtech Communications atYOU Hear Other Calls While Usingyour Phone Handset does not Ring When YOU Receive a CallYour Caller Fades in and OUT Common Cure for Electronic EquipmentWhat does this limited warranty cover? Limited WarrantyHow long is the limited warranty period? What is not covered by this limited warranty?How do you get warranty service? Other limitationsLimitations FCC Part FCC & IC RegulationsUnited States Canada Vtech ElectronicsThis telephone is registered for use in Canada IC Industry CanadaRbrc R RbrcTechnical Specifications Page Issued
Top Page Image Contents