VTech 9126, VT 9123 Installation of Battery Pack in Handset, Follow the Instructions

Page 6

GETTING STARTED

INSTALLATION OF BATTERY PACK IN HANDSET

The Handset of your VT 9123/9126 is powered by a rechargeable battery pack. It charges automatically whenever the Handset is in the Base Unit. The battery pack needs charging when:

•The low battery icon and message are displayed:

•A double beep will be generated every 5 seconds.

To charge the battery pack, place the Handset in the Base Unit. The IN USE/CHARGE indicator will light to show the Handset is seated properly and the battery pack is charging. It is recommended that the battery pack should be charged for at least 16 hours initially. Afterwards, 8 hours of maintenance charging should be sufficient.

To replace the battery pack, follow the steps below:

1.Remove the battery case cover by pressing on the ridged lines and sliding downward.

2.Discard the old battery pack by pulling firmly on the battery cords. Don’t put the old battery pack in a trash compactor or a fire - it could burst. Please recycle.

3.Snap in the new battery pack, with the wires in the lower left corner. Insert the battery plug into the socket, aligning the two holes in the plug with the socket pins.

4.Place the cord in the case so it rests below the battery pack.

5. Replace the battery case cover by sliding the cover upwards.

6. Place the Handset in the cradle of the Base Unit to allow it to charge for 16 hours.

CAUTION: To Reduce the Risk of Fire or Injury, Read and

Follow the Instructions

IMPORTANT:

Do not dispose of this battery pack into household garbage. For information on recycling or proper disposal, consult your local solid waste collection or disposal organization.

1. Use only VTech rechargeable battery pack, or equivalent.

2.Do not dispose of the battery pack in a fire. The cell may explode.

3.Do not open or mutilate the battery pack. Released

electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

4.Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery pack or conductor may overheat and

cause burns.

To purchase replacement battery packs, call VTech at 1-800-595-9511.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Table of Contents Important Safety Instructions Parts Check List Telephone CordHandset Layout Dialing KeysBase Layout Installation of Battery Pack in Handset To purchase replacement battery packs, call VTech atFollow the Instructions Setting UP Your VT 9123/9126 Ringer SelectionTONE/PULSE Selection Wall Mounting Handset is in idle mode Handset DisplayIf the display says It means Making Calls Volume ControlBasic Operation MethodUsing Redial Answering CallsFlash Hold About Call History Caller ID/CALL Waiting IDReceiving and Storing Calls Review Caller IDDeleting Records from Call History Dial a Displayed NumberStore a Caller ID Record in Phone Book Memory Caller’s number Display Screen MessagesCaller’s name ErrPhone Book Store Memory NumbersEdit Numbers Stored in Memory Delete Numbers Stored in MemoryDial Memory Numbers Messages Waiting Until Messages Waiting isInstallation OperationBelt Clip Maintenance No Dial Tone Case of DifficultyPhone DOESN’T Work AT ALL Vtech Communications atYour Caller Fades in and OUT Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Usingyour Phone Common Cure for Electronic EquipmentHow long is the limited warranty period? Limited WarrantyWhat does this limited warranty cover? What is not covered by this limited warranty?How do you get warranty service? Other limitationsLimitations United States FCC & IC RegulationsFCC Part Canada Vtech ElectronicsIC Industry Canada This telephone is registered for use in CanadaRbrc Rbrc RTechnical Specifications Page Issued
Top Page Image Contents