VTech 9126, VT 9123 Handset does not Ring When YOU Receive a Call, Your Caller Fades in and OUT

Page 22

ADDITIONAL INFORMATION

IN CASE OF DIFFICULTY

THE HANDSET DOES NOT RING WHEN YOU RECEIVE A CALL.

•Ensure that the ringer is turned on.

•Make sure the telephone line cord is plugged firmly into the base unit and the telephone jack. Make sure the power cord is plugged in.

•You may be too far from the base unit.

•You may have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of the other phones.

YOUR CALLER FADES IN AND OUT.

•You may be nearly out of range. Move closer, or relocate the base.

YOU HEAR OTHER CALLS WHILE USINGYOUR PHONE.

•Press CHAN key to switch to another channel.

•Disconnect your base unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Call your local telephone company.

YOU HEAR NOISE IN THE HANDSET, AND NONE OF THE KEYS OR BUT- TONSWORK.

•Make sure the power cord is plugged in.

•Your base unit and handset may not be operating on the same channel. Place the handset in the cradle for a few moments to reset the channel.

COMMON CURE FOR ELECTRONIC EQUIPMENT

Electronics, like people, can sometimes get confused. If the unit does not seem to be responding normally, then try putting the handset in the cradle to re-initialize the unit. If it still does not seem to respond, perform the following steps (in the order listed):

1.Disconnect the power to the base.

2.Disconnect (remove) the handset battery.

3.Wait a few minutes.

4.Connect power to the base.

5.Install the handset battery pack.

6.Put the handset in the base to re-initialize. If the handset has not been recently charged, allow 16 hours before use.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Table of Contents Important Safety Instructions Parts Check List Telephone CordHandset Layout Dialing KeysBase Layout To purchase replacement battery packs, call VTech at Installation of Battery Pack in HandsetFollow the Instructions Ringer Selection Setting UP Your VT 9123/9126TONE/PULSE Selection Wall Mounting Handset Display Handset is in idle modeIf the display says It means Making Calls Volume ControlBasic Operation MethodAnswering Calls Using RedialFlash Hold About Call History Caller ID/CALL Waiting IDReceiving and Storing Calls Review Caller IDDial a Displayed Number Deleting Records from Call HistoryStore a Caller ID Record in Phone Book Memory Caller’s number Display Screen MessagesCaller’s name ErrPhone Book Store Memory NumbersDelete Numbers Stored in Memory Edit Numbers Stored in MemoryDial Memory Numbers Messages Waiting Until Messages Waiting isOperation InstallationBelt Clip Maintenance No Dial Tone Case of DifficultyPhone DOESN’T Work AT ALL Vtech Communications atYour Caller Fades in and OUT Handset does not Ring When YOU Receive a CallYOU Hear Other Calls While Usingyour Phone Common Cure for Electronic EquipmentHow long is the limited warranty period? Limited WarrantyWhat does this limited warranty cover? What is not covered by this limited warranty?Other limitations How do you get warranty service?Limitations United States FCC & IC RegulationsFCC Part Canada Vtech ElectronicsIC Industry Canada This telephone is registered for use in CanadaRbrc Rbrc RTechnical Specifications Page Issued
Top Page Image Contents