VTech IP 811 manual FCC, ACTA, and IC Regulations, FCC Part, IC Industry Canada

Page 15

Additional Information

FCC, ACTA, and IC Regulations

This equipment complies with Parts 15 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations RSS210 and CS-03 of Industry and Science Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

A label is located on the underside of the base unit containing either the FCC registration number and Ringer Equivalence Number (REN) or the IC registration number and Load Number. You must, upon request, provide this information to your local telephone com- pany.

This equipment is compatible with inductively coupled hearing aids.

Should you experience trouble with this telephone equipment, please contact:

FCC Part 15

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installa- tion. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

To ensure safety of users, the FCC has established criteria for the amount of radio fre- quency energy that can be safely absorbed by a user or bystander according to the intended usage of the product. This product has been tested and found to comply with the FCC criteria. The handset has such a low power that it does not require testing. It may be safely held against the ear of the user. The base unit shall be installed & used such that parts of the user’s body other than the hands should be maintained at a comfortable distance of approximately 20 cm or more.

IC (Industry Canada)

This telephone is registered for use in Canada.

The term “IC:” before the radio certification number only signifies that Industry Canada technical specifications were met.

14

Image 15 Contents
Page Important Safety Instructions Important Safety Instructions Parts Check List Handset Layout Setup Connecting Power to Handset ChargerInstallation of Battery Pack Checking for Dial Tone Charging of the Handset BatteryStarted RegistrationHandset Icons Handset IndicatorsHandset LEDs DescriptionHeadset Operation Headset OperationMaintenance Handset Does Not Ring WhenYou Receive a Call Case Of DifficultyPhone Doesn’t Work At All No Dial ToneWhat is not covered by this limited warranty? Warranty StatementWhat does this limited warranty cover? How long is the limited warranty period?Other Limitations How do you get warranty service?FCC, ACTA, and IC Regulations FCC PartIC Industry Canada FCC, ACTA, and IC Regulations Nominal Effective Range Technical SpecificationsTable Of Contents Need HELP? ISSUE0