VTech IP 811 manual Setup, Connecting Power to Handset Charger, Installation of Battery Pack

Setup

Connecting Power to Handset Charger

Because the IP 811 is an accessory handset to the IP 8100-2/8100-3 all you need to do is choose the location for your handset charger and plug in the power supply into an electrical outlet.

CAUTION: Use only the VTech power supply provided with your telephone.

Installation of Battery Pack

1. Remove battery compartment cover by pressing on the indentation and sliding downward.

2. Place the new battery pack in the hand- set with the positive and negative poles aligned in the battery compartment.

3. Replace the battery pack cover by slid- ing it upwards.

4. If the new battery is not already charged, place the handset in its charger and allow it to charge for 10-12 hours.

5. After the initial charge, a maintenance charge of 10-12 hours should be suffi- cient. Be sure to place the handset in its charger when not in use to insure maximum daily performance.

6. Average talk time on a fully charged battery is about nine hours, standby time is approximately four days.

Getting Started