VTech I6717 important safety instructions Telephone base for charging

Page 33

Troubleshooting

Problem

Suggestion

 

 

 

The CHARGE Indicator

This is a signal that the battery is very low, completely depleted, or when there is no electrical

on the telephone base

 

contact between the battery and the telephone base.

is flashing.

Ensure the connector of the battery is securely plugged into the handset and place the handset

 

 

in the telephone base for charging.

 

 

 

There is no dial tone.

First, try all the above suggestions.

 

• Move the cordless handset closer to the telephone base. It might be out of range.

 

• The telephone line cord might be malfunctioning. Try installing a new telephone line cord.

 

Disconnect the telephone base from the telephone jack and connect a different telephone.

 

 

If there is no dial tone on the telephone either, the problem is in your wiring or local service.

 

 

Contact your local telephone company.

 

 

 

The telephone does not

Make sure the ringer is on. (See page 9).

ring when there is an

Make sure the telephone line cord and power adapter are plugged in properly (see page 3).

incoming call.

• The cordless handset may be too far from the telephone base. Move it closer to the telephone

 

 

 

base.

 

There may be too many extension phones on the telephone line to allow all of them to ring

 

 

simultaneously. Try unplugging some of them.

 

• If the other telephones in your home are having the same problem, the problem is in the wiring

 

 

or local service. Contact the local telephone company (charges may apply).

 

• Other electronic products can cause interference to your cordless telephone. Try installing your

 

 

telephone as far away as possible from the following electronic devices: wireless routers, radios,

 

 

radio towers, pager towers, cellular telephones, digital telephones, intercoms, room monitors,

 

 

televisions, VCRs, personal computers, kitchen appliances, and other cordless telephones.

 

 

 

30

www.vtechphones.com

Image 33
Contents Congratulations Table of contents Table of contents Parts checklist InstallationInstall handset battery Telephone base installation Headset Belt clip & headset optionalIf you subscribe to DSL service Desk/table bracket installation Wall mounting bracket installation optionalHandset layout Telephone settingsTelephone base layout Ringer tone Ringer volumeLanguage Key toneDial type Clear voicemailMake, answer and end calls Basic operationSpeakerphone MuteVolume Ringer muteCall waiting Voicemail Find handsetAdvanced operation DirectoryStore a directory entry Character chart Dial a directory entry Search the directoryDelete a directory entry Edit a directory entryAbout caller ID Review the call log Caller IDSave an entry to the directory Dial a call log entryCall log display screen messages Delete one or all entries in call logRedial list Dial from redialDelete a redial entry Handset display screen messages Appendix Handset lights Handset and telephone base indicatorsTelephone base lights Handset iconsBattery Problem Suggestion TroubleshootingCharge light is off in this section Telephone base for charging For this to take place Same outlet or near a microwave oven My caller ID features are To synchronize Important safety instructions Operating range MaintenanceAbout cordless telephones WarrantyHow do you get warranty service? FCC, Acta and IC regulations Rbrc seal Technical specifications Index Store a directory entry 91-001052-010-100 User’s manual