VTech VT 1930c manual Getting Started, Handset Ringer

Page 12

GETTING STARTED

Setting Up Your VTech VT 1930 c Choose an area near an electrical outlet and a telephone wall jack.

AC Power Adapter

Plug the AC power adapter into an electrical outlet and the DC connecter to the back of the base unit.

TELEPHONE

WALL JACK

AC

OUTLET

9V DC TEL. LINE

PULSE	TONE PULSE
TONE	TONE PULSE
	SWITCH
ON	BASE RINGER
OFF	BASE RINGER
RINGER	ON/OFF
	SWITCH

Charge the handset battery pack before use. The battery pack recharges automatically whenever the handset is in the base unit. The batteries must be charged for 16 hours before using your phone for the first time.

CAUTION:

Use only CLASS 2 9V DC POWER SUPPLY included with your phone.

CHARGE THE HANDSET

1

4 GHI

7 PQRS

*TONE

POWER

MEM

HOLD

HS IN-U

Handset Ringer

The handset ringer is programmed ON as the factory default setting. Refer

BATTERY PACK FOR 16 HOURS BEFORE USING

INT.COM

to PROGRAMMING THE RINGER for more information.

Setting the Tone/Pulse Switch The TONE/PULSE switch is located on the bottom of the base unit and is factory set to TONE. If you have touch tone service, do not change the switch setting. If you have rotary (Pulse) service, set the switch to PULSE.

DIGITAL 90

CORDLESS

Connect Telephone Line Cord Plug one end of the telephone cord into a wall jack and the other end into the back of the Base Unit.

12

Image 12

Contents Introduction Special Features Parts Check List Wall MountingFCC and IC Regulations FCC PartFCC and IC Regulations FCC and IC Regulations Important Safety Instructions Read and understand all instructionsImportant Safety Instructions Replacing the Battery Pack To Charge The Battery Pack Its Impossible To Overcharge The Battery Pack Word About Rechargeable Batter- iesTo Replace The Handset Battery Pack Follow The Steps Below DownwardSpare Battery Charger InstallationPower Backup Replacing a Drained Handset batteryGetting Started Handset RingerFill in the telephone number card on the base unit Wall Mounting Examples of the Handset Display Handset Display MessagesLCD DISPLAY-EXAMPLES Base Unit Function Keys Handset Layout Base Unit Layout Base Unit Features Quick Reference Guide INT.COStoring Memory Speed Dial Numbers Memory Dialing speed Dialing From the Handset¥ Press MEM/PROG From the Base Unit Press the Speaker Phone keyUsing Redial From the Handset From the Base UnitRedial Hold Basic Operation FlashRedial MuteBasic Operation Switching calls using Flash Advanced FunctionsCall Waiting Message WaitingTemporary Tone Programming The RingerChanging Ringer Types Advanced Functions Clear/Delete CLR/DEL Key Advanced DialingMulti Level Redial Memory Dialing Storing Memory Speed Dial numbersDialing From Memory From the Handset Changing Stored Numbers Deleting Stored NumbersDeleted Storing Special CodesCaller ID CID Receiving and Storing CallsDialing From Caller ID CID Memory Special Message Indicators Out of Area Calls Transmission ErrorÒPrivateÓ Calls PrivateReviewing Numbers Reviewing NumberDeleting Numbers Additional Operating Tips Noise Or InterferenceAutomatic Security Coding Out Of Range indicationMaintenance Cleaning your telephoneAvoid water Electrical stormsHandset does not Ring When YOU Receive a Call YOU Hear Other Calls While Using Your PhoneCase of Difficulty Phone Doesnõt Work AT ALLCommon Cure for Electronic Equipment Warranty Statement Technical Specifications Table of Contents Issue