BASIC OPERATION
Making Calls
From the Handset:
Press the PHONE key and wait for dial tone. Then dial the number you want.
Or
Enter the number onto the display first, then press the PHONE key. This will dial the number that is displayed on the display after 2 seconds. See
ADVANCED DIALING.
If you make a mistake when dialing, press OFF to hang up, then press the PHONE key to get the dial tone again.
From the Base Unit:
¥Press the SPKP key and wait for dial tone. Then dial the number you want.
Disconnecting
To end a call, either place the handset back in the base, press OFF on the handset, or press SPKP on the Base Unit (for speakerphone calls).
Answering Calls
From the Handset:
Press any key other than OFF , MUTE or the VOLUME keys to answer your call.
From the Base:
Press the SPKP key.
VOLUME Controls-Handset
The volume controls for the handset are located on the side of the unit.
Press the (up) or (down) keys
to increase or decrease the volume. Holding either key down will continuously change the volume setting. The earpiece volume level indicator on the display will change accordingly. There are four volume levels.
FLASH
You can use your VTech VT 1930c cordless phone with services such as Call Waiting. Simply press the PHONE key to FLASH the line.
REDIAL
To REDIAL the last number you dialed, press the PHONE key, then press REDIAL . The phone will automatically dial the number. The number will be shown on the display.
Clearing The Display
The display can be cleared by pressing and holding the CLR/DEL key down until the display clears.
MUTE
¥Press MUTE during an active call to disable the microphone.
¥Press MUTE again to return to normal operation.
Ringer MUTE
¥Press MUTE during incoming ringing to disable the ringer for the duration of the call.
HOLD
¥Press HOLD on the Handset or Base Unit to place an active call on hold.
¥To return to the call on the Handset,
press either PHONE or HOLD .
¥To return to the call on the Speakerphone, press either HOLD or SPKP .
24